Bobcat S850 W4320 Error Code
W4320 Error Code
"Manbasket mode : Remote control not connected to Manbasket harness (from Receiver CAN Bus signal)" is the main cause of W4320 error.The condenser converts gases into liquids, which expels heat from your rig. Materials can build up over time, causing a layer of dirt and grime to form on the condenser's coils. Your AC system will only blow hot air since the refrigerant fails to cool down.
Tip For S850 Model
The lifting capacities were calculated with a Standard
Configuration Machine (machine equipped with a pin-on
interface and no attachment). The weight of the
attachment, hydraulic clamp (if equipped) and different
interface must be subtracted from the lift capacity, to
obtain the actual lift capacity.
For bucket weights, see your Bobcat dealer. For attachment weights, see the attachment Operation &
Maintenance Manual.